Troubleshooting 1000pro slave unit
|
Troubleshooting 1000pro slave unit
|
21-Feb-2017, 09:26
you should definitly format the SD card before you copy the firmware files on it. I had a similar issue some years back. I was able to copy the files on the SD card without any problem, but the update on the Devialet fails. Then I have formatted the SD card and copied the firmware files again. Then it was working fine. The message on your Devialet is clearly stating that the update fails, so I don't think you have a faulty unit.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Troubleshooting 1000pro slave unit - by sam1000 - 17-Feb-2017, 05:38
RE: Troubleshooting 1000pro slave unit - by thumb5 - 17-Feb-2017, 08:15
RE: Troubleshooting 1000pro slave unit - by sam1000 - 17-Feb-2017, 08:53
RE: Troubleshooting 1000pro slave unit - by Vivialet - 17-Feb-2017, 09:55
RE: Troubleshooting 1000pro slave unit - by sam1000 - 21-Feb-2017, 07:14
RE: Troubleshooting 1000pro slave unit - by Pim - 21-Feb-2017, 08:36
RE: Troubleshooting 1000pro slave unit - by Vivialet - 21-Feb-2017, 09:26
RE: Troubleshooting 1000pro slave unit - by SwissBear - 21-Feb-2017, 13:02
RE: Troubleshooting 1000pro slave unit - by Pim - 21-Feb-2017, 14:56
RE: Troubleshooting 1000pro slave unit - by SwissBear - 21-Feb-2017, 17:41
RE: Troubleshooting 1000pro slave unit - by sam1000 - 21-Feb-2017, 20:47
RE: Troubleshooting 1000pro slave unit - by sam1000 - 22-Feb-2017, 18:59
|
