19-Dec-2018, 03:32
I have had that problems usually after firmware upgrades or hardware upgrades back from the factory.
Usually it is to do with (1) Different firmware versions between the master and the slave; (2) Connection problem with the link cable; (3) Sequence of booting up of the master and the slave, master first is usually fine.
As with Murphy's law, Typically it is a combination of the above. So I would try upgrading both units with the same firmware again, replacing a link cable, and, unplugging both units and re-connect the master first and then the slave. Usually it is fine. I have had one incident of a multiple link cable did not want to budge, but it worked in the end with one of the cables. But for some reason, all cables after that worked fine afterwards.
Usually it is to do with (1) Different firmware versions between the master and the slave; (2) Connection problem with the link cable; (3) Sequence of booting up of the master and the slave, master first is usually fine.
As with Murphy's law, Typically it is a combination of the above. So I would try upgrading both units with the same firmware again, replacing a link cable, and, unplugging both units and re-connect the master first and then the slave. Usually it is fine. I have had one incident of a multiple link cable did not want to budge, but it worked in the end with one of the cables. But for some reason, all cables after that worked fine afterwards.
Kondo Overture PM-2i, Weiss DAC502, LP12 Haben, Aro, Keel, Radikal, Urika, EMT JSD6, Phasemation PP-300/T-300, Linn Krystal, Penaudio Serenade Signature
Kondo Operia SPs 2.7, KSL-VzII, Acz-Avocado, etc.
Kondo Operia SPs 2.7, KSL-VzII, Acz-Avocado, etc.
