Help! How to use a D250 as ONLY a Preamp
|
Help! How to use a D250 as ONLY a Preamp
|
11-May-2015, 16:17
I am using the exclusively the preout function (in my case filtered low pass) and have no problem. All inputs must be set to allow preout. Did you dedicate preout on/off on your remote (I do not)? I previous firmware versions the preout only worked after the SD-card was inserted and the amp switched off and on again.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Help! How to use a D250 as ONLY a Preamp - by Caligari - 10-May-2015, 20:06
RE: Help! How to use a D250 as ONLY a Preamp - by Kunter - 10-May-2015, 20:23
RE: Help! How to use a D250 as ONLY a Preamp - by Caligari - 10-May-2015, 20:29
RE: Help! How to use a D250 as ONLY a Preamp - by thumb5 - 10-May-2015, 21:25
RE: Help! How to use a D250 as ONLY a Preamp - by Caligari - 10-May-2015, 21:48
RE: Help! How to use a D250 as ONLY a Preamp - by thumb5 - 10-May-2015, 21:50
RE: Help! How to use a D250 as ONLY a Preamp - by Caligari - 10-May-2015, 23:39
RE: Help! How to use a D250 as ONLY a Preamp - by Pim - 11-May-2015, 11:46
RE: Help! How to use a D250 as ONLY a Preamp - by Caligari - 11-May-2015, 11:59
RE: Help! How to use a D250 as ONLY a Preamp - by Music or sound - 11-May-2015, 16:17
|
