Stabilant 22

[Kunter]

I finally found the time to try the Stabilant 22.
I used it on every possible low current contact. Starting with my music PC from the PSU output connectors, power connectors on the mother board, power connector on the SSD drive, contacts on the memory slots, SATA connectors, PCI slot (USB card), USB contacts on USB card,
I also used it on the connectors of the USB cable and both ends of the speaker cables, the jumper cables and all ethernet connectors between the music PC and the NAS.
I did not use more than 2 or 3 ml of a 15 ml undiluted bottle
What can I say.
It’s quite difficult to make a direct A to B comparison as it took quite some time to disassemble the PC to reach all the important places. However the sound seems to have improved. It sounds more fluent, rounder, natural. The background seems darker, decays lasting longer, better ambient impression of the recordings.
I’m aware that it’s all very personal and subjective, but I’m very happy with the end result.
Taking into account the reasonable asking price it seems a “no brainer” tweek.

Glad you liked it...

In fact it gets a little better over time... just give it a couple of days... Especially for the speaker cable connections, which in my experience did not like stabilant immediately but needed to settle in.

For the contacts you dont disengage, there is no need to reapply. But for the ethernet and USB connections, it would be wise to reapply if you remove cables for any reason...

Stay away from any power connectors though...

Kunter