26-Mar-2016, 14:33
(This post was last modified: 26-Mar-2016, 14:51 by deviousalet.)
The trigger cable is a standard 3.5mm on both ends. My D400 came with an unbranded white 31"/78cm-long trigger cable. I hear D900 owners get an AudioQuest Sydney trigger cable with their Original d'Atelier so I'm sure other standard 3.5mm cables work.
Connected the trigger cable to the lower trigger port of the master (labeled TRIGGER IN/OUT) and upper trigger port of the slave unit (labeled RS-232/OPTICAL 2).
In the Configurator, configure the Chaining connection between master and slave to "Share sources from Companion" and enable at least one input on the slave (I enabled the digital input).
In the attached picture I've highlight the applicable portions of the Configuration screen as I've configured it.
Connected the trigger cable to the lower trigger port of the master (labeled TRIGGER IN/OUT) and upper trigger port of the slave unit (labeled RS-232/OPTICAL 2).
In the Configurator, configure the Chaining connection between master and slave to "Share sources from Companion" and enable at least one input on the slave (I enabled the digital input).
In the attached picture I've highlight the applicable portions of the Configuration screen as I've configured it.