2.12.5 and the problem returns

[AcrossTheWaves]

When Iconnect a Swissonic ADC to Gold directly, the sound will briefly be heard for the first few seconds and then quickly cut off.  Then there is no sound.  
And after that, it sends a message that the optical connection is not found. 
The same phenomenon on the left and right, and the cable also changed three things, but it is the same phenomenon. 

In this forum, someone inquired about 24ㅡ192 support to the Devialet technical team and said that they received an official reply saying that they only support 24ㅡ96 by optical input..  

If you are OK, you are very peculiar and lucky man.

So I switched to adc that supports 24-96 and now it works fine regardless of the cable.

Interesting. I've followed a bit the backtrack from Devialet about 24/192-24/96 (now 24/48), so I'm pretty sure it's get downsampled, but i'm OK with that.

I got a bit afraid because I haven't used the ADC since the last two updates. So I just tried now: It is NOT working or very badly working with a 1M amazon basics cable, but with a 30CM one it is still working fine. I'm not really sure that all optical are supposed to reach 24/192. Cable does a lot there. I guess it also depends on your Phantom version (hardware version, not software), because they were really capable to do that at least at some point. I got a June 2019 Phantom (M22P) and a Nov 2019 (L49N). Haven't tried the optical on the Nov 2019 as I was too lazy to put the optical cable in the Tree, and now I am too lazy to remove the Phantom from it to do it again.

Note that the 1M optical cable was plugged to my computer and I was using it perfectly with no issues in 24/96 (My integrated sound card cannot do 192).

When did you get your Golds ? AFAIK at the time I brought mine it showed 24/192.