Posts: 433
Threads: 20
Joined: Apr 2015
Reputation:
3
you need to change the "full range" selection to either high pass or low pass first.
Amp - Devialet 400 Speakers - vivid audio B1 Speaker cable - audioquest oak Power conditioner - furman SPR 16IE Source - audio PC with paul pang audio usb card v3 and paul pang red dual usb cable running through jplay. usb card powered by teddy pardo power supply Source 2 - line in from integra AV receiver (TV)
Posts: 137
Threads: 38
Joined: Feb 2015
Reputation:
0
I did. . .I have the sub outs set to low pass. When I go into the speakers section I cannot the setting.
Posts: 1,999
Threads: 23
Joined: May 2014
Reputation:
44
Do you have sam enabled? You can't use both at the same time.
PS Audio P3, Shunyata ΞTRON Alpha Digital and HC/Furutech power cables, Paul Hynes SR7EHD-MR4, DIY Roon Server & Roon Endpoint running AudioLinux Headless, Phasure Lush^2 USB cable, Audioquest Diamond RJ/E ethernet, Uptone Audio etherREGEN, Mutec MC-3+ USB, Shunyata ΞTRON Anaconda Digital XLR AES/EBU, Devialet Expert 250 Pro CI, Nordost Tyr Reference LS cables, Von Schweikert VR-5 SE Anniversary Edition, Anti-Mode Dual Core 2.0, JL Audio Fathom F112. More detail here.
The Netherlands
Posts: 1
Threads: 0
Joined: Nov 2018
Reputation:
0
01-Nov-2018, 17:21
(This post was last modified: 01-Nov-2018, 18:14 by racinggreen.)
I have bought a D-Premier two weeks ago and wish to use two subs REL T5 with my Guarneri Loudspeakers, one in front left, one in the back right. I want to connect them by low level connections.
What are the correct settings for it?
Mono pre-out with the subs together or stereo pre-out using the two coax inputs?
I tried to make the configuration using stereo pre-out and connected the subs but there is no sound.
Any ideas what I have to do to bring them to work?
Is there something to to in the configuration mode which is not obvious if you are a newbie?
Greets and thanks in advance
Thomas