Wrong config

[Zappydev]

Hello all,

Just bought a secondhand 400 and updated firmware to the latest 10.1.0.

Have now setup the device accordingly through the online configurator but the Master 200 refuses to recognize the config file and showing 'wrong config', companion device reads the file fine.

Have followed through on 'Pim's advice' on here, tried the configuration on Mac and PC via Chrome, firefox etc....and still the Master device refuses to read the config file.

Really pulling my hair out over this, any suggestions to what else it could be?

Thanks in advance for your time!

James

So both units updated fine to the new firmware? Should prove that the SD slot is working. What happens if you try to configure the master as an ordinary 200?

You might also try reinstalling the FW on both units, and have a look at the versions of each of the modules by scrolling through the display on each one in case something is out of whack.