njaiswal Wrote:Reactor Custom Mode
* Mini-jack connection only (both Analog and Optical)
* Volume fixed to 100%
* Volume setting available on sensor buttons
* BT + Airplay disabled
* Hardware reset only (protected from Power cycling)
Step1: Factory Reset
— Plug-in your Reactor and wait for the LED light to turn white or green
— Long Press on the back button (10sec)
— LED should turn purple and produce a distinctive short sound
— After ~1mn LED will fade in White then turn solid Green
Step 2: Entering Custom mode
— Press simultaneously (+) and (-) top button for 10 seconds
— LED will blink White then turn Green again when you release
— Plug-in your mini-jack (optical or analog) to the back of Reactor within one minute
— LED will turn from Green to solid White
— Unplug Reactor for 10 seconds and plug it back
— That’s it! Reactor is ready in Custom Mode!
— You can check that the setup worked by pressing on the
Bluetooth logo on top of the speaker
—> The LED should not turn Blue
Hi,
I've just have Devialet support at Phone.
(great support/service)
This is not Optical Direct mode.... it's a Store mode, that's why latency is still high.
They are working on a update to add "optical direct" in next months.
Regards,
Olivier
IMAC -> MOTU 8A -> TOSLINK -> PHANTOM I RIGHT AUX OPTICAL INPUT-> ETHERNET CABLE between LEFT and RIGHT (60ms): 2X Phantom I 103 dB (2021) in STEREO MODE DOS 2.12.3 - app 1.14