Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
140 phono stage
#1
Hi,
I’m curious To know If there is any difference in the phone stage for the different cartridges or it is only a matter of output level. In this case would be easy to use cartridges not in the list simply adjusting the right level.
Reply
#2
Basic phono stage for higher output level. 140 for MM or relativ high level MC with 0,4 mV and more. Would recommend Clearaudio MM Jubilee or above MC Hana ML or MM Clearaudio Charisma or DS Audio E1 optical cart with it’s own phono pre.

My fav is the E 1


Gesendet von iPad mit Tapatalk
Reply
#3
Ok, but the question is how to set the phono stage for a cartridge not listed. Have I to leave blank the drop down and fix only the sensitivity? In this case only MM cartridges can be used?
Reply
#4
If the cart isn‘t on the list, then choose MM and level with the max or bit above of the max volume of your cart.
Which cart do you use?

   

Enable
AuoWifi off
Start up Curve RIAA 1976
96 kHz sampling rate

Short >> only sensivity


Gesendet von iPad mit Tapatalk
Reply
#5
Shouldn’t the autowifi standby be switched to on? Supposedly the wifi interferes with the phonostage which degrades the output signal.
Devialet 220 pro expert; Focal 1028 Be; Rega RP6; Ortofon Quintet Orange
Reply
#6
(16-Jul-2020, 08:52)Elztalbiker Wrote: If the cart isn‘t on the list, then choose MM and level with the max or bit above of the max volume of your cart.
Which cart do you use?



Enable
AuoWifi off
Start up Curve RIAA 1976
96 kHz sampling rate

Short >> only sensivity


Gesendet von iPad mit Tapatalk
Thanks. This is what i was supposing. I’m thinking about Gold note vasari red.
Reply
#7
(17-Jul-2020, 10:04)Out of Gum Wrote: Shouldn’t the autowifi standby be switched to on? Supposedly the wifi interferes with the phonostage which degrades the output signal.
Yes, that’s correct. If you leave auto wifi standby in the off position you will hear an intermittent fluttering sound when using the phono input.
Project Eperience X Pack with Ortofon Rondo Red MC, Oppo BDP 105D, 2 x Sonos Connect, QNAP HS251+ NAS with 2 X 6TB Western Digital Red, Mac 5K 32GB running Lifetime Roon, iPad Pro 12.9" for remote control.  Etalon Ethernet Isolator, Devialet 440 Pro CI, Sonus faber Olympica ll with Isoacoustics Gaia ll feet, Auralic Taurus Mkll headphone amp.Denon AH-D5000, Sennheiser HD600 and HD800 with Cardas cable,  Van Den Hul The First Ultimate and Crystal interconnects, Furutech power cables, GSP Audio Spatia speaker cable.
South Coast England
Reply
#8
Don’t you think it is strange that the default setting is ‘off’?
Devialet 220 pro expert; Focal 1028 Be; Rega RP6; Ortofon Quintet Orange
Reply
#9
Gold Note has a output = 4,0 mV. That value should you choose linke sensivity

Auto wifi off is the best figure. Otherwise you could earn interferences.

Gesendet von iPad mit Tapatalk
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)