(23-Jul-2015, 13:27)Rufus McDufus Wrote: [ -> ]New firmware 8.1.3 is up on the Devialet site by the looks of it.
Thanks for the info. Just taking a look and downloading.
What is meant by the date under?
Firmware: 8.1.3
14-05-2015
Listening to it right now. Can't say I hear any difference with 8.1.2
And AIR over Ethernet only lasted for 1 song... bugger!
(23-Jul-2015, 14:09)CharlesL Wrote: [ -> ] (23-Jul-2015, 13:27)Rufus McDufus Wrote: [ -> ]New firmware 8.1.3 is up on the Devialet site by the looks of it.
Thanks for the info. Just taking a look and downloading. What is meant by the date under?
Firmware: 8.1.3
14-05-2015
I think that's the date of 8.1.2.
the latest filedate is from yesterday.
Is the configurator different from before ? How is the "custom delay feature" working ?
I just upgraded the firmware to 8.1.3.
However, after inserting the cards with the configuration files, the master unit is not visible through the wireless router that it is connected to with an ethernet cable, and so I cannot control the units (master and slave) with the control app on my ipad.
Also, the remote does not seem to work either.
When pressing the power button, only the master unit goes to off for a second and then is back on immediately.
Would appreciate your help to troubleshoot and fix this issue.
Thank you!
Downloaded and working fine so far at under 2 minutes albeit the slowest FW load to-date. More later if anything good, fun, interesting or newsworthy occurs...
(23-Jul-2015, 14:11)Pim van Vliet Wrote: [ -> ]Listening to it right now. Can't say I hear any difference with 8.1.2
And AIR over Ethernet only lasted for 1 song... bugger!
One thing to look out for with 8.1.2 vs 8.1.3 is the difference in SAM implementation and the effect of SAM % etc. Obviously this will vary from speaker to speaker, but in my case there was a big difference with SAM.
(23-Jul-2015, 15:26)miro Wrote: [ -> ]I just upgraded the firmware to 8.1.3.
However, after inserting the cards with the configuration files, the master unit is not visible through the wireless router that it is connected to with an ethernet cable, and so I cannot control the units (master and slave) with the control app on my ipad.
Also, the remote does not seem to work either.
When pressing the power button, only the master unit goes to off for a second and then is back on immediately.
Would appreciate your help to troubleshoot and fix this issue.
Thank you!
Download the firmware again and try to reload it. If that doesn't work also create a new configuration from scratch.
For some reason SAM whent to 0% when i loaded the new firmwear 8.1.3 had to turn it up manually